Here are some more.

Taken in the field just off Mason Rd. in the Falls looking westbound on the railbed. The edge of the field is the raised portion of the old railbed and the top of the picture would be where that hard right turn shown on the Mills Blueprints would then take you across the field, across Mason Rd. (Then called Weeks Mills Rd) past the Depot and on to Farmington. The old maps are confusing as this road and one parallel to it 4+ miles ahead in New Sharon were both called Weeks Mills Road. One of these trees has barbed wire embedded in more than a foot.

Looking eastbound after the railbed leaves the field area. It is hard to see here, but maybe clearer if you readers go back to the Farmington Chronicle article and remember how this four rod strip (64 feet) was cleared ripping trees and roots up leaving workable soil to be moved into the middle with ditches on each side. That is the only way to follow to old roadbed looking for the raised portion between two ditches.

My guide, Birchard Cook, standing on the raised railbed to give you readers an idea of how the walking is if you should attempt this. We are headed eastbound toward New Sharon but are still on the Farmington town side.

Still slogging eastbound, lots of swailgrass, better have good boots on, and we are now approaching the first little stream and some granite to observe. Not quite to the unmarked New Sharon yet.

The first granite culvert we encountered at about the Farmington/New Sharon Town Line, though unmarked. This is a small stream that was dammed by beaver about 25 years ago, but we can still see some of the granite work of Mr Currier, the stone worker, as mentioned in the Farmington Chronicle story of 10/7/1897.

A close up of one block about 1.5X2.5X4. Not a lot of effort was made to smooth up the edges when this was cut either on Cape Cod Hill in New Sharon, or maybe Chesterville Hill which was closer to this location. I can't remember the name of the high wheeled hauler used to move heavy granite pieces. Somehow the big slabs were suspended between the wheels for the mile or two journey from quarry to destination. This project must have been a real boon to the area as lots of man and horse power was needed.

The upstream side of the culvert and the beaver dam. My guide says he used to catch large trout here before the dam was built.

The downstream side. These granite pieces are not light and were all handled manually. Remember granite weighs 168 pounds per cubic foot and even these small culverts were a real challenge. The workmanship still looks pretty good after 112 years of weathering.