Within the Moody/Baricelli collection that the Museum acquired earlier this year, was an assortment of metal artifacts. Some, such as two spikes, were tagged as being from certain locations on a Colorado three foot gage railroad. One item was not tagged, but recognizable as being a handwheel from a steam locomotive injector or one of the tri-cox valves. The handwheel was wrapped with wire, to allow a locomotive crew member to open or close the valve without wearing gloves. I made an assumption that the item was also from Colorado, pending any other information.
Well, now six months later, there may be a bit of information as to where that handwheel came from. Linwood Moody had taken photographs of one of the Knox Railroad locomotives, both inside the cab and on the ground. One of the photos shows a wire wrapped handwheel on a locomotive backhead. Still, I was.not moved by this to determine the origin of that component.
This psst Saturday, at Sheepscot, Zack loaned me his copy of the 1997 Warren, Maine Historical Society hardcover book, "Old Warren, Maine". Earlier today, I read into the railroad history section and took note of a few things.
Engine no. 5 (Built by Rhode Island in 1885) was cut up for scrap in 1939. Engine no. 6 hauled the wrecking train and finished up in May of 1939. It was sold for scrap, but then resold to the U.S. Government.( Presumably at the end of World War Two) it was resold to the Smithfield Ham Company. It was finally cut up in 1960.
Based on information in the book, I'm now thinking that handwheel was liberated from engine no. 5. Maybe Linwood wanted a little souvenir of his hometown (Union, Maine) railroad.
If I see his photos to be of the Knox engine no. 5, I'm going to be about 99 percent certain that this is the case. I will mark the handwheel as such, but with "assumed to be from no. 5".
What do you think of this conclusion/assumption? If this item is ever to be displayed publicly, do you think such documentation to be helpful?