« previous next »
Pages: [1]   Go Down

Author Topic: Cylinder oil  (Read 7954 times)

Robert Hale

  • Hostler
  • ***
  • Posts: 213
    • View Profile
Cylinder oil
« on: August 19, 2008, 01:52:06 AM »
What type of cylinder oil is used on #10? I know #10 is not superheated so would the lube oil used be different than a loco that has a superheater (and thus a hotter steam output)?
What will #11's driver wheel diameter be? What would the cost of a new boiler be in today's dollers?
Thanks, just leaner some more about these locos.
Rob
Logged

Keith Taylor

  • Museum Member
  • Engineer
  • ****
  • Posts: 742
  • Life Member
    • View Profile
Re: Cylinder oil
« Reply #1 on: August 19, 2008, 01:27:20 PM »
Rob,
I can't say positively as I am not involved in running No. 10, but it is usual for saturated locomotives to use SAE 600W steam cylinder oil, which contains tallow. Superheated locomotives definitely use different oils as the higher temperature steam washes the tallow based lubricants off of the cylinder walls.
Keith
Logged

Steve Smith

  • Museum Member
  • Engineer
  • ****
  • Posts: 649
  • Life Member
    • View Profile
Re: Cylinder oil
« Reply #2 on: August 22, 2008, 06:47:10 PM »
Rob,

No. 11 is to be a replica of No. 7, which had 33-inch drivers.

Steve Smith
Logged
Pages: [1]   Go Up
« previous next »