I ran across this sub-two foot system, which once ran in the deep woods of West Virginia, just across the border from Virginia. It's a 60ccm system which once connected with the standard gauge Winchester and Wardensville in Wardensville, WVA. The equipment is WW1 surplus. 2-6-2T's, maybe 5 of them and identified as Vulcan products, provided the inspiration to roll the lumber to the interchange. It looks like they weren't real particular as to where they put then engine. The line was owned by Winchester Lumber Company, some photos also calling it the Lost River Railroad, which sounds like a Disney attraction. A couple of photos identify it as the "J. Natwick & Company". I think that may have been a company which succeeded Winchester Lumber/Lost River.
The map shows three branches radiating from Wardensville, which appear to be several miles (or should I say kilometers, since it's 60cm?) in length.
I stole these pictures from the "Wardensville" fb site. I've tried to attach photos with this fascinating lecture, but was rebuffed at any, as they apparently exceed four, which is the maximum allowed. I will attempt an additional post, which will not exceed four.